When performing a haircut, cross-checking is essential. To some, this might appear to be an unnecessary step, but it is important to ensure the cut is also and proportional. When carrying out a small haircut, check always for blending and declining in the reflection (or stand back several feet). Usually, you will see points from a distance that you will skip up close. Also be sure to have proper light from all angles. Gray gentle and shadows ensure it is very hard to check on for quality in the cut.
The first step in excellent mixing is avoiding lines of demarcation in the very first place. When performing clipper work, proceed through three steps with each stroke. Begin with the clipper attached with the entire flat work surface of the knife pressing the head. Going upward, pivot the clipper so just the heel (back) of the blade is touching. Next, hold the clipper freehand since it moves up and out of the hair. This can create the smoothest change possible.
One approach to blending between taglio capelli uomo and shear perform is to use the clipper-over-comb method. With this technique, work with a detachable edge clipper with a sizable knife (#1 1/2 or higher). The larger edge will give the customer a better blend as the hair will be reduce a uniform size with a feathered end. Never work with a short blade or trimmer to blend since the knives will give the hair a very dull cut and leave a lot of small lines of demarcation.
Another way of blending is blending-shears-over-comb. Carry the hair up with the brush and use the mixing shears to reduce the past 1/4" of the hair. When raising the hair, it is very important to somewhat overdirect before cutting as this may produce a better blend. Make sure to just cut the past 1/4 '" to 1/8" of hair. Never slim hair near the head as this may produce a unclear look by creating very small locks to stand out through the lengthier hairs. Use a loss shear with at least 40 teeth. Shears with greater teeth can produce lines. Prevent applying normal shears to blend because the knives can give the hair a really frank reduce and keep a lot of small lines of demarcation.
You may also create a mix utilizing a common straight razor (without a comb attachment). The hair is raked with the blade at a 45 amount angle. The viewpoint of the knife is quite important. If the blade is presented in a far more compressed place, too much hair is likely to be removed. If the knife is used more straight, it will injury the cuticle. That approach was made common by the Roffler colleges and shouldn't be tried before you have obtained hands-on teaching by a barber/stylist who is qualified in the technique. For razor blending, it is essential that the hair be really wet.